Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Chevrolet Venture model year.
Safety recall notices and repair campaigns registered for the 1997 Chevrolet Venture in Canada.
On certain vehicles equipped with second-row bucket seats or captain's chairs and power sliding door on the passenger side, if a passenger uses the interior handle to open the power sliding door and holds onto the handle while it is being opened by the motor, the passenger's arm may be pushed into the seat back or armrest and a wrist or lower arm injury may result. Correction: Dealers will replace the original interior power sliding door handle. The original handles are offset from the door panel and a passenger can wrap his or her fingers around them. The replacement door handles are essentially flush with the door trim, preventing a passenger from gripping them in the same fashion.
A failure of this component (other) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the lower pinion bearings retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between January 1, 1996 and October 31, 1997 may fail and permit the ball bearings to escape. If the problem were to occur, the driver would have to exert more effort to turn the steering wheel. Correction: Dealers are to inspect the condition of the lower bearing, and replace the lower pinion bearing or the rack and pinion steering gear assembly, if necessary.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain 1997-2001 Chevrolet Venture, Pontiac Montana/ Trans Sport, and Oldsmobile Silhouette mini vans equipped with passenger side power sliding doors that were serviced in campaign 01013 (01v-067) from April to August 2001. Also 2001 Chevrolet Venture, Pontiac Montana, and Oldsmobile Silhouette mini vans equipped with passenger side power sliding doors assembled in January through April 2001. These vehicles have inadequate front welds. If a front weld fails, the actuator can jam in the unlatched position and, when the sliding door closes, it will not be latched. If this happens, the power sliding door can open while the vehicle is in motion, particularly when the vehicle ascends a hill, makes a turn, or travels over a rough road surface. An unrestrained occupant could fall out of the van and be injured. Correction: dealers will inspect the actuators for certain date codes and, if necessary, replace the actuators.
A failure of this component (other) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain vehicles may exhibit a condition in which the power sliding door closes, but is not latched, If this happens the power sliding door can open while the vehicle is in motion, particularly when the vehicle ascends a hill, makes a turn, or travels over a rough road surface. An unrestrained occupant could fall out of the vehicle and be injured. Correction: Dealers will install a new power sliding door un-latch actuator assembly.
A failure of this component (structure) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles operated in areas of high salt use, the spare tire hoist cable may corrode and eventually break. This would allow the spare tire to fall off the vehicle possibly resulting in a road hazard for other vehicles. Correction: A letter will be sent to owners of affected vehicles with maintenance and inspection instructions for spare tire hoist cable assemblies. Additionally, the letter will advise the owner that, if the cable breaks during that inspection, their dealer will repair the assembly. This policy will be in effect until December 31, 2002.
A failure of this component (accessories) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, ice may accumulate on the rear brake pipes located approximately under the driver's side floor mat. If a large amount of ice accumulates on the brake pipes, the weight of the buildup may pull the pipes away from the underbody of the vehicle which could cause the pipes to drag on the ground and be damaged. Damaged brake pipes could result in loss of brake fluid and reduced brake effectiveness. Correction: A brake pipe retainer clip will be installed to the underbody.
A failure of this component (brakes) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: VEHICLES EQUIPPED WITH BUCKET SEATS OR A SPLIT BENCH SEAT IN THE MIDDLE OR BACK ROW. THE SEAT LATCH RELEASE MECHANISMS ON BUCKET SEATS AND ON THE 40% PORTION OF THE SPLIT BENCH SEAT IN THE SECOND AND THIRD ROWS DO NOT HAVE PROTECTIVE COVERS. WHEN ACTIVATING THE RELEASE MECHANISM TO ROLL A BUCKET SEAT FORWARD, AN OPERATOR'S FINGERS MAY BE SEVERELY INJURED OR SEVERED IF THEY ARE NOT KEPT CLEAR OF THE MECHANISM. CORRECTION: DEALERS WILL INSTALL A PROTECTIVE COVER OVER THE RELEASE MECHANISM.
A failure of this component (seats and restraints) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: VEHICLES EQUIPPED WITH TRACTION CONTROL. WHEN THE WINDSHIELD WIPERS ARE TURNED ON, THE WINDSHIELD WIPER LINKAGE ARM MAY CONTACT A BRAKE LINE CONNECTED TO THE TRACTION CONTROL SYSTEM (TCS) MODULATOR. THIS COULD RESULT IN BRAKE FLUID LEAKAGE, REDUCED BRAKING EFFECTIVENESS AND INCREASED STOPPING DISTANCES. CORRECTION: A BRAKE LINE CLIP WILL BE INSTALLED WHICH WILL ASSURE PROPER CLEARANCE. ADDITIONALLY, VEHICLES WILL BE INSPECTED FOR BRAKE LINE DAMAGE CAUSED BY THIS CONDITION AND DAMAGED BRAKE LINES WILL BE REPLACED.
A failure of this component (brakes) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.