2013 Freightliner 108sd Recall

Certain trucks were built with tires that are not approved for use with the truck's wheels. As a result, the tires may not perform properly, or a tire could fail.

A tire failure could cause a loss of control and increase the risk of a crash.

Daimler Trucks North America (DTNA) will notify owners by mail. The corrective actions for this recall are under development. You will be instructed to bring your truck to a DTNA authorized service facility when a repair is available.

On certain trucks equipped with electronic stability control (ESC), the brake lights may turn on when the automatic traction control (ATC) activates. Canadian regulations do not allow brake lights to turn on when the automatic traction control activates.

Brake lights that turn on when a vehicle is not slowing could confuse other drivers.

The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility. The truck will either be reprogrammed or retrofitted so the brake lights do not turn on when the automatic traction control (ATC) activates.

Certain trucks were built with air reservoir tanks that are too small in relation to the size of the air brake chambers. Canadian regulations require enough air reservoir capacity to ensure the brakes work even with heavy use or when there is a partial loss of the air system.

Reduced braking could cause extended stopping distances and increase the risk of a crash.

The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility to modify the truck to ensure it meets Canadian regulations.

On certain vehicles, the rear disk brake calipers may contact the spring suspension due to incorrect caliper orientation. This could reduce rear brake effectiveness which would result in increased stopping distances, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will correct the orientation of the rear calipers.

A failure of this component (brakes) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain trucks, the seat belts may not comply with Canada Motor Vehicle Safety Standard 209 - Seat Belt Assemblies. Due to a defect in manufacturing, the seat belt buckle may not release as required by the standard. This could hinder egress from the vehicle in an emergency, increasing the risk of injury. Correction: Dealers will inspect and, if necessary, replace affected seatbelt buckles.

A failure of this component (seats and restraints) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain trucks, the customizable SmartPlex switch hub module may experience intermittent electrical shorts. As a range of equipment may have been connected to the switch hub module by final stage vehicle manufacturers; depending on vehicle configuration and intended use, these electrical shorts could have varied consequences. These may include the erratic operation of emergency, warning and/or work lights, the unexpected activation of a remote engine starter or the intermittent and/or uncontrolled operation of other body equipment. These or other malfunctions may result in an increased risk to road users, operators or bystanders. Correction: Dealers will inspect and, if necessary, replace the switch hub module.

A failure of this component (electrical) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, the wheel rims may have been manufactured incorrectly and could fail. A wheel separating from the vehicle could cause a loss of control and a crash. In addition, the errant wheel assembly could strike a vehicle, stationary object, or a bystander. These issues could result in property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the wheel rims. Note: Further evaluation revealed that no Canadian vehicles are involved.

A failure of this component (wheels) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain trucks, the quick release valve (QRV) cover may not have been welded correctly during manufacturing process and may become loose or separate from the valve body. If this occurs, air pressure may not be supplied to the front brakes during brake application. The rear brakes will continue to function. Reduction in braking efficiency could increase stopping distances, possibly resulting in a crash causing property damage and/or personal injury. Correction: Daimler authorized repair facilities will inspect and if necessary replace the quick release valve.

A failure of this component (brakes) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, an incorrect steering wheel fastener may have been installed during vehicle assembly. The incorrect nut may not provide the clamp load required to fully seat the steering wheel onto the steering shaft. This could allow the steering wheel to wobble, which could hamper vehicle operation. If the problem is ignored, the nut could loosen completely, which could allow the steering wheel to detach from the steering shaft. These issues could result in a crash causing property damage and/or personal injury. Correction: Dealers will replace the steering wheel nut.

A failure of this component (steering) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).