Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Freightliner Century model year.
Safety recall notices and repair campaigns registered for the 1996 Freightliner Century in Canada.
The TRW tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardness. This can lead to premature wear out and a possible separation of the ball stud from the socket and loss of steering control. Correction: All affected tie rods and drag links with different design ends will be replaced.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the windshield wiper connecting linkage sockets may wear out prematurely due to insufficient greasing during assembly. This may lead to a separation of the linkage and loss of wiper function. Correction: Windshield wiper connecting linkages will be removed and replace with new links that are properly lubricated.
A failure of this component (visual system) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
THE U-JOINT DEFLECTOR RINGS MAY BE LOOSE, ALLOWING WATER TO ENTER THE U-JOINT BEARING AREA RESULTING IN DILUTION OF THE LUBRICANT, OXIDATION OF BEARING AND SEAL SURFACES, AND LOSS OF LUBRICANT. THIS COULD RESULT IN SEPARATION OF THE INTERAXLE DRIVELINE. CORRECTION: VEHICLES WILL BE INSPECTED FOR LOOSE DEFLECTOR RINGS, AND IF LOOSE, THE U-JOINT WILL BE REPLACED WITH A NEW DESIGN VERSION.
A failure of this component (powertrain) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
LEAKS THROUGH THE FIREWALL OR STEERING SHAFT BOOTS MAY ALLOW WATER TO RUN DOWN THE STEERING SHAFT. THE STEERING SHAFT SPLINE MAY BECOME CORRODED CAUSING IT TO SEIZE. THIS CAN RESULT IN AN INCREASE IN THE EFFORT TO STEER THE VEHICLE. CORRECTION: STEERING SHAFT WILL BE REPLACED WITH ONE OF A NEW DESIGN THAT IS INSTALLED IN AN INVERTED ORIENTATION SUCH THAT NO WATER CAN ENTER THE SPLINES.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 210 - SEAT BELT ASSEMBLY ANCHORAGES. THE B-PILLAR ANCHORAGE DID NOT MEET THE LOADING REQUIREMENTS OF THE STANDARD DUE TO UNDERSIZED RIVETS AND OVERSIZED HOLES. CORRECTION: LARGER RIVETS WILL BE INSTALLED ON AFFECTED UNITS.
A failure of this component (seats and restraints) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: VEHICLES EQUIPPED WITH TILT/TELESCOPING STEERING COLUMNS. THE FOUR FASTENERS THAT RETAIN THE OUTPUT SHAFT BEARING TO THE STEERING COLUMN TILT/TELESCOPING MECHANISM MAY NOT HAVE BEEN TORQUED PROPERLY. IF THESE FASTENERS BECOME LOOSE AND FALL OUT, THE STEERING COLUMN DRIVELINE WILL DISCONNECT FROM THE TILT/TELESCOPING MECHANISM AND STEERING CONTROL WILL BE LOST. CORRECTION: THE LOWER TWO FASTENERS WILL BE REPLACED WITH BUTTON HEAD SCREWS AND PREVAILING TORQUE NUTS AND THE UPPER TWO FASTENERS WILL BE RETORQUED.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: VEHICLES EQUIPPED WITH OPTIMIZED IDLE FEATURE. IF THE IGNITION IS TURNED ON AND THE FUSE FOR THE ELECTRONIC CONTROL MODULE (ECM) POWER FEED LINE IS REMOVED OR BURNED OUT, uNINTENTIONAL CRANKING OF THE ENGINE WILL OCCUR, BYPASSING THE SAFETY FEATURES DESIGNED TO PREVENT INJURY TO PERSONS WORKING IN THE VICINITY OF THE ENGINE AND TO PREVENT VEHICLE MOVEMENT. CORRECTION: VEHICLES WILL BE REWIRED WITH A REVISED ECM TO ELIMINATE UNINTENTIONAL CRANKING.
A failure of this component (engine) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
AN ELECTRICAL SHORT MAY OCCUR IN THE AUXILIARY HEATER/AC BLOWER MOTOR IF EXPOSED TO WATER. THE SHORTED RELAY MAY RESULT IN A FIRE. CORRECTION: RELAY WILL BE REPLACED WITH ONE THAT RESISTS SHORTING IF CONTACTED BY WATER AND DOES NOT SUPPORT COMBUSTION EVEN IF SHORTED.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.