Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Honda Prelude model year.
Safety recall notices and repair campaigns registered for the 1988 Honda Prelude in Canada.
On certain vehicles, the platic front seatbelt release buttons may break allowing plastic pieces to fall into the buckle assembly. If this should happen, a no latch, false latch or failure to unlatch condition could occur creating the risk of personal injury in the event of a crash or sudden stop. Correction: Front seatbelt buckles will be repaired or replaced as necessary.
A failure of this component (seats and restraints) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the accelerator pedal stopper may be bent when excessive downward force is applied after the pedal has contacted the stopper. In the worst case, the edge of the pedal can be caught and held down by the bent stopper. This could result in loss of vehicle control and a crash without prior warning. Correction: A support will be installed to prevent the stopper from bending.
A failure of this component (engine) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the power steering supply hose at the connector clamp seal could develop a small leak. If the fluid were to contact the exhaust manifold a fire could result. Correction: A reinforced rubber power steering hose assembly will be installed.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain Prelude SI vehicles, throttle body castings may contain slight porosity. During vehicle usage, coolant seepage may occur and eventually residue may accumulate on the throttle valve. The residue could cause the throttle valve to return slowly from the slightly open position to the idle position when the accelerator pedal is released. Correction: The throttle body assembly will be replaced.
A failure of this component (engine) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.