Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Ic Bus Be School Bus model year.
Safety recall notices and repair campaigns registered for the 2006 Ic Bus Be School Bus in Canada.
On certain vehicles equipped with an INTERNATIONAL® VT365 engine, the engine calibration normally responds to a failed open accelerator position sensor circuit fault by returning the engine to low idle speed of 800 rpm and disabling the driver's ability to increase the engine speed. However, If the open circuit condition corrects itself within 30 seconds of its initiation the engine calibration misinterprets this event by going into a "limp home mode" where the engine speed is increased from low idle speed to the high idle speed of 1200 rpm. This increase to high idle speed may occur without warning causing a sudden and unexpected shift in vehicle position possibly resulting in property damage, personal injury or death. Correction: Dealers will install an updated engine calibration.
A failure of this component (powertrain) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain buses, the heater blower motor located in the entrance door stepwell heater unit as well as the rear wall-mounted heater unit may fail. This could result in elevated temperatures that could ignite nearby combustible materials. A vehicle fire could cause property damage, personal injury or death. Correction: Dealers will affect repairs
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain buses may exhibit engine hard start, no start, or stall conditions due to possibly damaged terminals in the fuse holder connector of the Injector Drive Module (IDM) clean battery power circuit. These terminals may have been damaged during electrical continuity testing done during the manufacturing process. Loss of vehicle propulsion, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash. Correction: Dealers will affect repairs.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.