CANADA Transport Canada Safety Recalls
EN FR
auto-recalls.ca

Canadian Safety Recalls Database

Home / International / 3400 / 1999 International 3400
2 Active Safety Recalls

1999 International 3400 Recall

Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.

2
Safety Recalls
CMVSS
Safety Standard
Transport Canada
Official Source
VIN Decoder

VIN Decoder

Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.

Active Safety 1999 International 3400 Recalls (2)

Safety recall notices and repair campaigns registered for the 1999 International 3400 in Canada.

Ref #2002-165 Campaign : 02510
2002-09-18 3 711 units

Brakes

Issue Description

On certain vehicles, the TRW Model 410M ECU (Electronic Control Unit) can misinterpret particular false wheel speed signals generated from any of the following conditions: An incorrect gap between the sensor and tone ring, a chaffed sensor wire, connector corrosion, sensor vibration or quality of harness and pin-outs. If one of these conditions occurs, the ECU could not distinguish between an actual low friction event on road surface and a low amplitude sensor signal and would activate the ABS brakes, instead of deactivating the ABS in response to a false signal. The driver would experience a hard brake pedal during the middle to end of a braking event and a decrease in deceleration at the end of the stop. The driver may experience an unexpected extended stopping distance, which could result in a collision. The ABS warning indicator light may not come on to warn the driver of a system malfunction. Correction: Dealer will affect repairs. Note: recall superseded by 2004171 and 2004172.

Safety Risk

A failure of this component (brakes) may increase the risk of a crash or injury.

Corrective Action & Repair

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

Free parts & labor under Motor Vehicle Safety Act Transport Canada Open Data
Ref #1999-206 Campaign : 99508
1999-11-12 550 units

Brakes

Issue Description

On certain vehicles, the rear hydraulic brake hoses that drop from the frame down to the axle for ABS brake systems may be either too long or too short. On vehicles where the hose is too long, a chafing condition exists on suspension components, which could result in hose rupture. On vehicles where the hoses are too short, a hose separation may occur with severe suspension articulation. Premature failure of a rear drop-hose would result in the loss of the rear brakes and could cause a crash without prior warning. Correction: Short hoses will be replaced while long hoses will have a hose routing kit installed to prevent any chafing problems.

Safety Risk

A failure of this component (brakes) may increase the risk of a crash or injury.

Corrective Action & Repair

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

Free parts & labor under Motor Vehicle Safety Act Transport Canada Open Data
Vehicle Profile & Safety Standards

Vehicle Specifications & Compliance Benchmark

Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.

Safety Recall Coverage
2 bulletins
Transport Canada safety defect records
Safety Compliance
CMVSS / NSVAC
Motor Vehicle Safety Act standards
NRCan EnerGuide
Trim-Specific
Varies by engine, drive & transmission
VIN Specifications
14 Attributes
Decode exact engine & plant via VIN above

All International 3400 Model Years

Explore safety recall records by model year.

View Model Overview