Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another International 9400 model year.
Safety recall notices and repair campaigns registered for the 1997 International 9400 in Canada.
On certain vehicles, the automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the slack adjusters to function as manual slack adjusters. If the support bracket for an automatic slack adjuster fails, the brakes at that wheel end will not automatically adjust. As the brake linings wear, the vehicle will have reduced braking capacity, increasing the risk of a crash. Correction: Dealers will install a new bracket on each suspect slack adjuster.
A failure of this component (brakes) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the front hubs may have less than an infinite fatigue life if used with a thin brake drum. If a wheel hub experiences fatigue failure the result could be complete wheel separation from the vehicle. This could in turn cause loss of vehicle control and a crash without prior warning. Correction: Both front wheel hubs will be replaced on affected vehicles.
A failure of this component (suspension) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain vehicles may have experienced loosening of the end yoke retaining nut. If this condition occurs, the driveline can vibrate and separate from the vehicle, causing vehicle damage or personal injury or both. Correction: Center bearing package and coupler shaft will be replaced with a new coupler shaft and a 60mm center bearing package.
A failure of this component (powertrain) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: VEHICLES EQUIPPED WITH PROSLEEPER. A MICRO RELAY LOCATED BEHIND THE HVAC CONTROL PANEL IN THE BUNK OF THE PROSLEEPER MODELS CAN CORRODE IN THE PRESENCE OF MOISTURE, WHICH COULD CAUSE A SHORT CIRCUIT BETWEEN CONTACTS ON THE RELAY. THIS COULD RESULT IN A VEHICLE FIRE. CORRECTION: RELAY WILL BE REPLACED WITH A SEALED RELAY.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
THE WIRING FROM THE ELECTRONIC CONTROL UNIT MAY HAVE BEEN CONNECTED TO THE WRONG WHEEL SENSOR. SHOULD THE ABS WIRING BE CROSSED, IT WOULD RESULT IN A SIGNIFICANT DEGRADATION IN BRAKE STABILITY. A SIGNAL WOULD BE SENT TO THE WRONG BRAKE CHAMBER WHEN A BRAKE IMBALANCE IS DETECTED. THIS COULD RESULT IN A VEHICLE ACCIDENT WITHOUT PRIOR WARNING. CORRECTION: THE ABS WIRING WILL BE INSPECTED AND PROPERLY CONNECTED AS REQUIRED.
A failure of this component (brakes) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
MIS-MATCHED PARTS WERE ASSEMBLED ON SOME SIX SPOKE WHEEL ASSEMBLIES WHICH COULD CAUSE HIGH STRESSES IN THE WHEEL STUDS AND POTENTIAL WHEEL STUD FAILURES. THIS COULD RESULT IN WHEEL SEPARATION AND A POSSIBLE ACCIDENT WITHOUT PRIOR WARNING. CORRECTION: CORRECT PARTS COMBINATIONS WILL BE IMPLEMENTED AND OPERATOR INSTRUCTIONS AND VISUAL AIDS WILL BE UPDATED.
A failure of this component (suspension) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: VEHICLES EQUIPPED WITH EATON REAR AXLE ASSEMBLIES WITH ANTILOK WHEEL NUTS. THE WHEEL NUT LOCK TABS ON THESE VEHICLES MAY FATIGUE AND FAIL FROM CRACKING DURING SERVICE. THIS COULD RESULT IN SEPARATION OF THE WHEEL ASSEMBLY FROM THE AXLE HOUSING. A DISENGAGED WHEEL ASSEMBLY COULD POSE A HAZARD TO OTHER USERS OF THE ROADWAY AND ADJACENT PROPERTY. THIS CONDITION WOULD ALSO AFFECT VEHICLE STABILITY AND CONTROL AND COULD CAUSE A VEHICLE CRASH WITHOUT PRIOR WARNING. CORRECTION: ANTILOK WHEEL NUTS WILL BE REMOVED AND REPLACED WITH STANDARD WHEEL NUTS AND LOCK RING.
A failure of this component (suspension) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.