Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Mack Cx model year.
Safety recall notices and repair campaigns registered for the 2000 Mack Cx in Canada.
On certain vehicles, the headlamp switch may fail causing complete or intermittent loss of headlamp function. Should this occur during hours of darkness, it could result in a vehicle crash causing property damage, personal injury or death. Correction: Dealers will replace the headlamp switch.
A failure of this component (lights and instruments) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain heavy-duty trucks equipped with TRW 20-EDL Ball Sockets were manufactured with a case depth and/or hardness that were below specifications. A bearing that is below specification may prematurely wear-out the ball socket, which, in turn, may lead to a separation of the tie rod. Correction: Dealers will replace the tie rods.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain Class 8 heavy-duty trucks equipped with R.H. Sheppard M90 steering gears. An incorrect hose was used for the high-pressure line between the power steering pump and the steering gear. The hose is rated at 2000 PSI, while it should be rated at 3000 PSI. This hose could develop a leak or burst while in service. Should the line burst, steering control would still be maintained, but a loss of power assist will be experienced. Correction: Dealers will replace the steering hose.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain heavy-duty trucks equipped with TRW tie rod ends on certain Meritor axles. The tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardness. This can lead to premature wear with possible separation of the ball stud from the socket, increasing the risk of loss of control of the vehicle. Correction: Dealers will remove and replace all affected tie rods and drag links with different designed ends. Trucks that have been repaired under recall 00v246103/SC0262 will not be re-recalled. Trucks only inspected and determined to have an acceptable date code under SC0262 will be recalled under this campaign.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the return springs on the accelerator pedals are made of stainless steel or electroplated music wire. The design fatigue stress of the stainless steel springs is in a range that would predict that some failures would occur. The music wire springs can fail due to stress risers created by electrical arcing during electroplating. Correction: Accelerator pedals will be replaced with ones equipped with return springs manufactured of music wire with one additional coil on each spring and with an organic coating, eliminating electroplating.
A failure of this component (engine) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.