Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Micro Bird Mbii Commercial Bus model year.
Safety recall notices and repair campaigns registered for the 2015 Micro Bird Mbii Commercial Bus in Canada.
On certain buses, the anchor screw caps for the wheelchair restraint system may not have been installed properly. As a result, the tie-downs may not lock correctly and could detach in a crash. Note: This recall only affects certain buses equipped with a Q'Straint Slide N' Click wheelchair restraint system.
Tie-downs that detach in a crash could increase the risk of injury.
Micro Bird will notify owners by mail and provide you with instructions for how to inspect and, if necessary, secure the anchor screw caps for the wheelchair restraint system. Alternatively, you may schedule an appointment to have the repairs performed at a Micro Bird dealership.
On certain buses, the exterior handle for the rear emergency door may not be strong enough. As a result, the handle could break and cause the emergency door not to be able to be opened from the outside.
A door that can't be opened could slow your exit from the bus in an emergency. This could also delay emergency responders from entering the bus. Both issues could increase the risk of injury.
Micro Bird will notify owners by mail and advise you to take your bus to a dealership to replace the rear emergency door exterior handle.
On certain buses, the power cable for the air conditioning control board may have a loose connection. As a result, the circuit board could overheat and melt.
A circuit board that overheats could create the risk of a fire.
Micro Bird will notify owners by mail and advise you to contact a Micro Bird dealer to have your vehicle(s) repaired.
On certain buses, an unused wiring harness located in the B-pillar area could become damaged. If this happens, the wires could short circuit. Note: This recall only affects buses built on a General Motors chassis.
A short circuit could create the risk of a fire.
Micro Bird will notify owners by mail and provide you with instructions for how to inspect the wiring and correct this problem.
On certain buses, the service door may not be adjusted correctly. As a result, the door panels may get stuck when the emergency release handle is used, or may not open when force is applied to the door. Additionally, the exterior emergency release handle may not allow the service door to be opened from outside of the bus.
A door that cannot be opened could delay exiting the bus in an emergency. This could also delay emergency response. Both of these issues could increase the risk of injury.
Micro Bird will notify owners by mail and instruct you to take your bus to a dealer to adjust the service door. Alternatively, Micro Bird will provide owners instructions on how to correctly adjust the service door.
On certain buses, the passenger shoulder belt anchorage plate(s) may not be attached correctly. In the event of a crash, the belt anchorage plate may become partially or totally detached, reducing the capacity of the shoulder belt to retain the passenger, resulting in an increased risk of injury or fatality. Correction: Dealers will inspect, and if necessary, re-install the shoulder belt anchorage plate using the correct procedure.
A failure of this component (seats and restraints) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain buses may have been manufactured with defective T-sliding windows that could allow water to accumulate in the central horizontal bar and not drain out properly. If this condition is present during a cold period, the accumulated water could freeze, expand and permanently deform the horizontal center bar, applying a stress on the glass to a point where it could potentially shatter, increasing the risk of injury. Correction: Lippert Components Canada will provide instructions and some of the equipment necessary to the owners of the affected buses so that they can repair the faulty windows. The equipment that is not supplied is subject to a refund offer.
A failure of this component (structure) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles built on a Ford chassis, wheel alignment adjustment bolts may not have been sufficiently tightened at time of assembly. This could allow suspension and steering components to loosen, potentially resulting in separation, which could affect vehicle handling and steering and result in crash causing injury and/or damage to property. Correction: Owners will be given instructions on how to have the bolt tightening torque inspected.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.