Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Pontiac Montana Sv6 model year.
Safety recall notices and repair campaigns registered for the 2006 Pontiac Montana Sv6 in Canada.
Certain vehicles equipped with remote start capability fail to comply with the requirements of CMVSS 208 - Occupant Restraint Systems. The safety belt reminder light for the driver's seating position does not illuminate after the ignition key is inserted and turned to the 'run' position following a remote start. As well, the audible chime for the driver's seating position will not sound if the driver and a front seat passenger enter the vehicle following a remote start, the passenger buckles his/her seatbelt within 25 to 33 seconds after the remote start, and the ignition key is then turned to the 'run' position. Note: This non-compliance condition has no affect on vehicle safety. Correction: Dealers will recalibrate the Sensing Diagnostic Module (SDM) to activate an enhanced seatbelt reminder feature, which repeats the chime and telltale cycles up to two times if the seatbelt is not buckled and if the vehicles speed is over 8 km/h. This enhanced feature is already activated on 2007 vehicles.
A failure of this component (seats and restraints) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain Aztek (AWD), Montana (AWD), Relay (AWD), RendezVous (AWD), RendezVous (FWD), Silhouette (AWD), Terraza (AWD), Terraza (FWD), Uplander (AWD) and Venture (AWD) vehicles equipped with independent rear suspension, when operated in extreme cold temperature and on rough roads, water and salt can intrude past the ball joint seal. The combination of theses conditions may then lead to premature wear of the ball joint. If the ball joint wear progresses to the point of separation from the lower control arm, a loss of vehicle control may occur. Correction: Dealers will replace both ball joints with new ball joints which have a revised boot and ball stud to improve the seal to the ball stud shaft.
A failure of this component (suspension) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.