Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Pontiac Sunfire model year.
Safety recall notices and repair campaigns registered for the 1995 Pontiac Sunfire in Canada.
On certain passenger vehicles if the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts. If the switch is damaged, a fire could occur in the steering column, even with the engine off and the key removed. Correction: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Note: Certain 1997-99 vehicles in Ontario, Quebec and the Atlantic provinces and 1995-99 vehicles in all other provinces and territories. Moisture may enter the Powertrain Control Module (PCM) as a result of corrosion after extended exposure to road salt. This can lead to symptoms including illumination of the "Check Engine" light or the engine running rough. If these symptoms are ignored the engine may stall and may not be able to be restarted. Correction: Dealers will seal the Powertrain Control Module (PCM) in a protective shield/cover assembly.
A failure of this component (engine) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland, Moisture entering the Powertrain Control Module (PCM) as a result of corrosion can cause illumination of the "Check Engine" light or cause the engine to run rough. If these symptoms are ignored, the engine may stall and may not be able to be restarted. Correction: Dealers will inspect, clean and/or replace the Powertrain Control Module (PCM), then seal the PCM in a protective shield/cover assembly.
A failure of this component (engine) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING EQUIPMENT. VEHICLES MAY EXHIBIT A CONDITION IN WHICH THE FRONT AND/OR REAR HAZARD WARNING LAMPS (FOUR-WAY FLASHERS) DO NOT FLASH WHEN THE HAZARD SWITCH IS ACTIVATED. CORRECTION: VEHICLES WILL BE INSPECTED AND HAZARD LAMP SWITCH REPLACED IF NECESSARY.
A failure of this component (lights and instruments) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: VEHICLES WITH AUTOMATIC TRANSMISSIONS. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 101 - CONTROL LOCATION AND IDENTIFICATION. THE INSTRUMENT PANEL TRIM PLATE MAY SAG AND COVER THE LIGHT EMITTING DIODE OF THE SHIFT INDICATOR DISPLAY. IF THIS OCCURS, THE DRIVER MAY NOT BE ABLE TO DETERMINE THE ACTUAL POSITION OF THE TRANSAXLE GEAR SELECTOR AND COULD INADVERTENTLY LEAVE AN IDLING VEHICLE IN DRIVE, REVERSE OR NEUTRAL RATHER THAN IN PARK. THIS COULD RESULT IN A VEHICLE CRASH. CORRECTION: A NEW INSTRUMENT PANEL CLUSTER TRIM PLATE/BEZEL ASSEMBLY WILL BE INSTALLED ON AFFECTED VEHICLES.
A failure of this component (lights and instruments) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
THESE VEHICLES MAY HAVE BEEN BUILT WITH WELDS OMITTED FROM THE FRONT SUSPENSION LOWER CONTROL ARM ASSEMBLIES. THIS CONDITION COULD CAUSE EXCESSIVE LOADS ON EXISTING CONTROL ARM WELDS, AND COULD RESULT IN SEPARATION OF THE FRONT BUSHING-SLEEVE SUBASSEMBLY FROM THE CONTROL ARM. THIS COULD RESULT IN REDUCED STEERING CONTROL AND A CRASH WITHOUT PRIOR WARNING. CORRECTION: SUSPENSION LOWER CONTROL ARMS WILL BE INSPECTED AND THOSE FOUND WITH OMITTED WELDS WILL BE REPLACED.
A failure of this component (suspension) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.