2018 Tesla Model X Recall

A previous over-the-air (OTA) software update could cause the vehicle not to display the correct visual warning indicators when there are problems with the brake system or when the parking brake is applied. As a result, the BRAKE, PARK, and antilock brake system (ABS) visual indicators would display as text instead of symbols.

While there is a low risk to safety, Canadian regulations require visual warnings to use common symbols, instead of words, to avoid driver confusion.

Tesla will notify affected owners by email. Tesla has released an over-the-air software update to fix this problem. There is no further action required if your vehicle has software release 2024.3.25, 2024.14.5, or a release later than 2024.14.5.

On vehicles equipped with the Autosteer advanced driver-assistance feature, when using the feature, the vehicle may not provide strong enough warnings or monitor the driver closely enough to prevent misuse of the feature.

A driver that doesn't pay close attention while using the Autosteer feature or who doesn't react quickly when Autosteer is canceled could have an increased risk of a crash.

Tesla will notify owners by email and supply an over-the-air software update to improve driver monitoring and alerts while using the Autosteer feature. Tesla advises that you must always pay attention and be ready to take control of the vehicle at any time while using the Autosteer advanced driver-assistance feature.

In certain traffic situations, when the FSD Beta advanced driver assistance feature is engaged, the vehicle may perform maneuvers that break certain traffic laws, if the driver doesn't intervene and take control. Note: This recall only affects vehicles equipped with the FSD Beta feature.

Certain maneuvers performed by the FSD Beta advanced driver assistance feature may break traffic laws. This could increase the risk of a crash if the driver doesn't intervene.

Tesla will notify owners by email and supply an over-the-air software update to improve how the FSD Beta feature maneuvers the vehicle in certain traffic situations. Tesla reminds that FSD Beta is only an advanced driver assistance feature, and the driver must pay attention and be ready to take control at all times when the feature is engaged.

On certain vehicles, the internal memory for the media control unit (MCU) could run out of storage capacity over time. If this happens, the center display can turn off while driving and cause some of the car's systems not to work properly. This includes the rearview camera display, defrost/defog control settings, and exterior turn signal lighting.

A rearview camera image that does not display could reduce a driver's ability to see behind the vehicle while backing up. A windshield that cannot be defrosted/defogged could reduce visibility. Turn signals that do not work could cause a following driver not to recognize that a vehicle ahead intends to turn. These conditions could increase the risk of a crash.

Tesla advises owners to ensure that their vehicle software is up to date. Tesla will notify owners by email, including when parts are available to schedule service to upgrade the internal memory in the MCU.

On certain vehicles, when switching the distance display setting from kilometers to miles, the speedometer displays the vehicle speed in miles per hour (mph) only. Canadian regulations require that speed be displayed in either kilometers per hour (km/h) or in both km/h and mph.

This small error does not affect vehicle safety.

This is not a recall. Tesla has made changes to ensure that all new vehicle speedometers display mph and km/h when the display distance is set to miles. In addition, this change was sent to all vehicles in firmware update 2020.36.11.