Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Thomas Built Minotour School Bus model year.
Safety recall notices and repair campaigns registered for the 2018 Thomas Built Minotour School Bus in Canada.
On certain school bus seats, the plastic trim (bezel) where the shoulder seat belt comes out of the seatback may be too hard. Canadian regulations have requirements for anything that is installed in certain areas of the seatback. Note: This only affects school buses equipped with certain Syntec M2K and S3C passenger seats with lap/shoulder seat belts.
While this plastic trim is doesn't technically meet the requirements of Canadian regulations, it's unlikely to cause an injury.
This is not a recall. The company made changes in 2017, and all new seats made after that time have a soft vinyl cover trim for the shoulder seat belt.
This recall affects certain school buses equipped with SynTec S3B and/or S3C passenger seats. On some seats, the protective foam in certain areas of the seatback may not meet the knee impact requirements of Canadian regulations.
A seatback that does not have proper knee impact protection could increase the risk of injury to occupants in a crash.
The company will notify owners by mail and instruct them to take their vehicle to a Daimler Trucks of North America authorized service facility to install additional protective material in the seatbacks.
On certain school buses built on a Ford chassis and equipped with a wheelchair lift, the shift interlock may not prevent the wheelchair lift from operating while the vehicle gear shifter is in neutral or drive. If the vehicle were to move while the wheelchair lift is in operation, there would be an increased risk of injury. Correction: Daimler Trucks of North America Service Facilities will inspect the wheelchair lift wiring and repair as necessary.
A failure of this component (accessories) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain school buses equipped with Syntec S3B restraint seats, under extreme operating conditions, such as adverse road conditions, repetitive shock loads, or occupant abuse, a metal fatigue crack may develop on the rear wall mount bracket of the seat. Over time, this could lead to the wall mount bracket fracturing, which in the event of a crash, could increase the risk of injury to seat occupants. Correction: Daimler Trucks of North America Service Facilities will inspect seats and install an additional wall bracket between the wall rail and the seat as necessary.
A failure of this component (seats and restraints) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain school buses built on a GM chassis and equipped with a wheelchair lift, the shift interlock may not prevent the wheelchair lift from operating while the vehicle gear shifter is in neutral or drive. If the vehicle were to move while the wheelchair lift is in operation, there would be an increased risk of injury. Correction: Dealers will inspect the wheelchair lift wiring and repair as necessary.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.