2010 Toyota Prius Recall

This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. Note: This recall only affects the following block heater/cord part numbers: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903

Engine block heater wiring that overheats or melts could create the risk of a fire.

Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater.

This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act.

Glass that breaks in to large pieces could create a risk of injury.

The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.

On certain vehicles, the Intelligent Power Module (IPM), which is part of the hybrid drive system, could become damaged under certain driving conditions. This could cause various warning lights to illuminate on the instrument panel of the vehicle and cause a reduction or loss of motive power, increasing the risk of a crash causing injury and/or property damage. Correction: Dealers will update motor/generator and hybrid control ECU software and affect repairs as necessary. Note: This recall supersedes recalls 2014-042 and 2015-312. Vehicles repaired under the previous recall(s) will require repair.

A failure of this component (powertrain) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, a defect in the curtain shield airbags could cause the inflator to fail, releasing pressurized gas into the airbag, partially inflating it. If this occurs, parts of the inflator could also separate from the vehicle structure, entering the interior of the vehicle. Should this occur when occupants are in the vehicle, unintended airbag deployment could startle the driver, and airbag inflator parts could come into contact with the occupants, increasing the risk of injury and a crash. Correction: Dealers will install a retention bracket which will prevent the inflator parts from entering the vehicle interior.

A failure of this component (airbag) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, the Intelligent Power Module (IPM), which is part of the hybrid system inverter assembly, could become damaged under certain driving conditions. This could cause various warning lights to illuminate in the instrument panel of the vehicle and cause a reduction or loss of motive power, increasing the risk of a crash causing injury and/or property damage. Correction: Dealers will update motor/generator and hybrid control ECU software and affect repairs as necessary. Note: This recall is superseded by recall 2018546. Please see recall 2018546 for more information.

A failure of this component (powertrain) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, a fatigue crack could develop in the brake pressure accumulator. If this occurs, nitrogen gas could leak into the brake fluid and gradually cause the brake pedal stroke to become longer, resulting in decreased hydraulic pressure. This condition could result in longer stopping distances, increasing the risk of a crash causing property damage and/or injury. Correction: dealers will inspect the brake booster pump and, if necessary, replace it with an improved unit.

A failure of this component (brakes) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, an inconsistent brake feeling may be perceived after ABS actuation during slow and steady application of the brakes on rough or slick road surfaces and stopping distances may be increased compared to expectation for a given pedal force. Increased brake distance in a case of emergency may result in a crash causing property damage or personal injury. Dealers will rewrite the programming of the ABS control Unit.

A failure of this component (brakes) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).