Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Toyota Tundra model year.
Safety recall notices and repair campaigns registered for the 2017 Toyota Tundra in Canada.
This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. Note: This recall only affects the following block heater/cord part numbers: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903
Engine block heater wiring that overheats or melts could create the risk of a fire.
Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater.
On certain vehicles, a defect in the steering gear assembly could cause it to leak power steering fluid. If this happens, there could be a loss of power steering assist. Note: For 2007-2020 models, this recall only affects 41 vehicles that had a replacement steering gear installed in 2021.
A loss of power steering assist may result in a sudden increase in steering effort, especially at low speeds. This could increase the risk of a crash.
Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to inspect, and if necessary, replace power steering gear assembly.
Certain vehicles may fail to conform to Canada Motor Vehicle Safety Standard CMVSS 207 - Anchorage of Seats, CMVSS 210 - Seat Belt Anchorages, CMVSS 210.1 - User-ready Tether Anchorages for Restraint Systems and Booster Seats, and CMVSS 210.2 - Lower Universal Anchorage Systems for Restraint Systems and Booster Seats. One or more of the bolts fixing the left hand rear split seat bracket sub-assemblies to the floor pan may not have been tightened properly during assembly. This could allow the seat to move in the event of a crash, increasing the risk of injury to the seat occupant. Correction: Dealers will retighten the five seat leg bracket bolts.
A failure of this component (seats and restraints) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in a short circuit. A short circuit could lead to a fire which would increase the risk of injury and/or damage to property. Correction: For vehicles where the subject block heater was approved for installation, the dealer will replace the block heater assembly with a new one of an improved design. For vehicles where the subject block heater was not approved for installation, dealers will remove the block heater assembly. In the interim, until the remedy can be performed, dealers will cut the plug end from the block heater cord to disable the block heater's operation.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles equipped with the plastic rear step bumper, the resin reinforcement brackets that secure the step corners of the bumper could become damaged after a rear impact. If a person were to use the rear bumper steps with damaged resin reinforcement brackets, part of the bumper could break off which could cause the person to fall, increasing the risk of injury. Correction: Dealers will replace the resin reinforcement brackets with steel reinforcement brackets. In addition, the rear bumper tread covers will also be replaced.
A failure of this component (structure) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.