2010 Volvo Vhd Recall

Certain vehicles equipped with a snowplow preparation kit may fail to comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 108 - Lighting System and Retroreflective Devices. The snowplow headlamps can be turned on without other exterior lights, and the high beam indicator does not work when the snowplow high beams are turned on, which is contrary to the requirements of the standard. This could allow the vehicle to be operated with the snowplow headlamps on and marker and tail lamps off, making the vehicle harder to see and potentially increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will update vehicle software to correct the non-compliance.

A failure of this component (lights and instruments) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, a defect in the ball joint seals on the drag link could allow corrosion to form in the joint, leading to accelerated wear. This could result in ball joint failure, potentially resulting in a loss of steering control which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the non-greasable drag link with a greasable drag link.

A failure of this component (steering) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, the secondary clutch disengagement switch may have been omitted during vehicle assembly or, in some instances, removed during servicing. As such, primary switch failure would cause the automated manual transmission’s clutch to remain engaged when the brakes are applied. This could increase stopping distances, possibly resulting in a crash causing property damage and/or personal injury. Correction: Dealers will install a micro-switch at the brake pedal and update the software to run a diagnostic on the switch during engine start-up.

A failure of this component (other) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

Certain vehicles may fail to conform to Canada Motor Vehicle Safety Standard 210 – Seatbelt Assembly Anchorages. The weld used to secure the nut to the center-passenger seatbelt D-ring mounting bracket may not be sufficient to meet the strength requirements of the Standard. Failure of the seatbelt D-ring anchorage to restrain the occupant would increase the risk of personal injury during a crash. Correction: Dealers will replace the D-ring for the middle seating position.

A failure of this component (seats and restraints) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, the tire description may be incorrect on the certification label, which is a non-compliance to Canada Motor Vehicle Safety Standard 120 - Tire Selection and Rims. The description listed on the label may be for a tire with a lower rating that cannot support the Gross Axle Weight Rating (GAWR) listed, which may result in a potential tire failure. Correction: Updated labels will be mailed to owners of affected vehicles, along with instructions for proper installation.

A failure of this component (label) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).