Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Altec At Series model year.
Safety recall notices and repair campaigns registered for the 2017 Altec At Series in Canada.
On certain aerial devices, the front axle capacity may be too low. As a result, the vehicle could be overloaded. This could cause poor handling and lead to a loss of control. Note: This recall only affects certain Ford E350 van chassis with gross axle weight rating (GAWR) of 1837 kg (4050 lb.) or 1905 kg (4200 lb.).
A loss of control could create the risk of a crash.
Altec Industries will notify owners by mail and advise you to contact a Ford dealership or an authorized service facility to install upgraded front coil springs and hardware. Additionally, Altec Industries will provide you with a new compliance label with updated information.
On certain aerial devices, the wiring in the engine compartment may have been routed incorrectly. As a result, the wiring could become damaged by contact with the hood. If this happens, the wiring could short circuit and melt.
Wiring that overheats and melts could create the risk of a fire.
Altec Industries will notify owners by mail and advise you to contact Altec Service to inspect and, if necessary, re-route the wiring and fuse block. To reduce the safety risk, Altec advises to periodically inspect the wiring for signs of damage until the recall repairs are completed.
Over time, the 12-V power wire for the boom stow sensor on certain aerial devices could be damaged by contact with a sharp edge. If this happens, the wire could short circuit and blow the fuse for the ignition circuit. This can cause the engine to shut off suddenly while driving.
A sudden loss of engine power could increase the risk of a crash.
Altec Industries will notify owners by mail and instruct you to contact Altec Service to add a relay that is fused separately from the ignition circuit.
On certain aerial devices, the 120 V electrical outlet from the generator does not have proper circuit protection.
An electrical outlet that does not have circuit protection could create a fire risk.
Altec Industries will notify owners by mail and instruct you to contact Altec Service to install a new ground-fault circuit interrupter (GFCI) outlet with a circuit breaker and new wiring. Altec advises that you should only plug in appliances or tools that draw less than 20 A.
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.