Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Ford Crown Victoria model year.
Safety recall notices and repair campaigns registered for the 1996 Ford Crown Victoria in Canada.
On certain vehicles, a wiring harness that is not compatible with the vehicle circuit polarity may have been inadvertently installed during servicing for recall 2005028 or 2007258. As a result, the fuse is located in the output circuit rather than in the input power feed circuit, and will not offer the intended protection in the event of an electrical short to ground. This could result in a vehicle fire, causing property damage and/or personal injury. Correction: Dealers will install an updated wiring harness.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the speed control deactivation switch may overheat, smoke, or burn, potentially resulting in an underhood fire. The failure mode appears to be different than that of Recall 2005028 (05S28). This time, the concern is with long term durability performance issues causing the switch to fail. Correction: Initially as an interim repair, owners will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. As soon as replacement parts are available, owners will be instructed to return to the dealers for installation of a fused wiring harness designed to eliminate the potential risk of fire.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain natural gas vehicles, in the rare circumstance that a flame from a vehicle interior fire becomes locally directed at the natural gas tank located immediately behind the rear seat, the locally directed flame could damage the fiberglass wrap on the tank thereby reducing the hoop strength of the tank. If the hoop strength is significantly compromised, the tank could rupture and potentially result in personal injury. Correction: Dealer will install an insulator behind the seat back.
A failure of this component (fuel system) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain CNG vehicles do not comply with the requirements of CMVSS 1105 - Evaporative Emissions. The natural gas fuel fill valve may leak due to flaking of the nickel plating inside the valve. This will allow natural gas to escape into the atmosphere at a rate that exceeds the limits prescribed in the standard. Correction: Valve will be replaced with one of an alternative design.
A failure of this component (emissions) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Note: 1996-99 crown victoria police, fleet and ngv and lincoln town car limousine equipped with a lower control arm ball joint containing a one piece bearing and 1990-96 crown victoria police, fleet and ngv and lincoln town car limousine that were serviced with either a ball joint containing an one piece bearing or a front lower control arm with a one piece bearing. High bearing loads can lead to thinning and eventual cracking of the lower control arm ball joint. This can result in separation of the ball and cap of the joint. Should this occur, the control arm to which the cap is mounted will drop to the ground. Should this occur while the vehicle is moving, reduced steering control could result in a collision. Correction: Lower control arm ball joints will be replaced.
A failure of this component (suspension) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: POLICE INTERCEPTOR VEHICLES WITH 4.6 L 2V ENGINES. UNCURED SILICONE GEL MIGRATING DOWN THE MASS AIR-FLOW SENSOR (MAFS) SENSING ELEMENT SUPPORT POSTS MAY COLLECT DUST AND DIRT PARTICLES. THESE PARTICLES CHANGE THE THERMAL CHARACTERISTICS OF THE MAFS WHICH MAY CAUSE AN ENGINE DETONATION/SPARK KNOCK CONDITION. HEAVY DETONATION CAN CAUSE SPARK PLUG DAMAGE, INTAKE VALVE OVERHEATING, VALVE SEATING CONCERNS AND PISTON/RING DAMAGE POTENTIALLY RESULTING IN ENGINE FAILURE. CORRECTION: MASS AIR-FLOW SENSORS WILL BE REPLACED.
A failure of this component (engine) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: POLICE AND TAXI VEHICLES ONLY. THE HOOD LATCH STRIKER MAY EITHER WEAR OR BECOME DETACHED FROM THE HOOD. EITHER OF THESE CONDITIONS MAY RESULT IN THE HOOD OPENING WITHOUT WARNING WHILE THE VEHICLE IS BEING OPERATED RESULTING IN REDUCED DRIVER VISIBILITY AND A POSSIBLE CRASH. CORRECTION: VEHICLES WITH 1992 MODEL HOODS WILL HAVE AN IMPROVED HOOD LATCH STRIKER INSTALLED AND REVISED STRIKER PLATE ATTACHING FASTENERS WILL BE INSTALLED ON VEHICLES WITH 1993-97 HOODS.
A failure of this component (structure) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: CROWN VICTORIA POLICE INTERCEPTORS AND UNITS FOR COMMERCIAL APPLICATIONS. TOWN CARS WITH LIMOUSINE BUILDER PACKAGE OR TRAILER TOW PACKAGE. THE PITMAN ARMS ON THESE VEHICLES WERE NOT FULLY LUBRICATED DURING VEHICLE ASSEMBLY. IF NOT PROPERLY LUBRICATED IN ACCORDANCE WITH THE MAINTENANCE SCHEDULE, THE PITMAN ARM BALL JOINT MAY BECOME CONTAMINATED AND CORRODE. THIS COULD RESULT IN ABNORMAL WEAR AND POSSIBLE PITMAN ARM BALL JOINT SEPARATION CAUSING SUBSEQUENT LOSS OF STEERING CONTROL AND A POSSIBLE CRASH. CORRECTION: PITMAN ARMS WILL BE INSPECTED AND THOSE WITH SIGNIFICANT WEAR WILL BE REPLACED. THOSE PITMAN ARMS NOT REPLACED WILL HAVE THE BALL JOINT FULLY GREASED.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S 206 - DOOR LATCHES, HINGES AND LOCKS. THE DRIVER'S DOOR, WHEN CLOSED ONLY TO THE SECONDARY LATCHED POSITION, MAY NOT SUSTAIN A 1000 POUND TRANSVERSE LOAD AS REQUIRED BY THE STANDARD. CORRECTION: DRIVER DOOR LATCH WILL BE INSPECTED AND, IF NECESSARY, REPLACED.
A failure of this component (structure) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.