Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Ford Crown Victoria model year.
Safety recall notices and repair campaigns registered for the 1997 Ford Crown Victoria in Canada.
On certain vehicles, a wiring harness that is not compatible with the vehicle circuit polarity may have been inadvertently installed during servicing for recall 2005028 or 2007258. As a result, the fuse is located in the output circuit rather than in the input power feed circuit, and will not offer the intended protection in the event of an electrical short to ground. This could result in a vehicle fire, causing property damage and/or personal injury. Correction: Dealers will install an updated wiring harness.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the speed control deactivation switch may overheat, smoke, or burn, potentially resulting in an underhood fire. The failure mode appears to be different than that of Recall 2005028 (05S28). This time, the concern is with long term durability performance issues causing the switch to fail. Correction: Initially as an interim repair, owners will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. As soon as replacement parts are available, owners will be instructed to return to the dealers for installation of a fused wiring harness designed to eliminate the potential risk of fire.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain natural gas vehicles, in the rare circumstance that a flame from a vehicle interior fire becomes locally directed at the natural gas tank located immediately behind the rear seat, the locally directed flame could damage the fiberglass wrap on the tank thereby reducing the hoop strength of the tank. If the hoop strength is significantly compromised, the tank could rupture and potentially result in personal injury. Correction: Dealer will install an insulator behind the seat back.
A failure of this component (fuel system) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain CNG vehicles do not comply with the requirements of CMVSS 1105 - Evaporative Emissions. The natural gas fuel fill valve may leak due to flaking of the nickel plating inside the valve. This will allow natural gas to escape into the atmosphere at a rate that exceeds the limits prescribed in the standard. Correction: Valve will be replaced with one of an alternative design.
A failure of this component (emissions) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Note: 1996-99 crown victoria police, fleet and ngv and lincoln town car limousine equipped with a lower control arm ball joint containing a one piece bearing and 1990-96 crown victoria police, fleet and ngv and lincoln town car limousine that were serviced with either a ball joint containing an one piece bearing or a front lower control arm with a one piece bearing. High bearing loads can lead to thinning and eventual cracking of the lower control arm ball joint. This can result in separation of the ball and cap of the joint. Should this occur, the control arm to which the cap is mounted will drop to the ground. Should this occur while the vehicle is moving, reduced steering control could result in a collision. Correction: Lower control arm ball joints will be replaced.
A failure of this component (suspension) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: POLICE AND TAXI VEHICLES ONLY. THE HOOD LATCH STRIKER MAY EITHER WEAR OR BECOME DETACHED FROM THE HOOD. EITHER OF THESE CONDITIONS MAY RESULT IN THE HOOD OPENING WITHOUT WARNING WHILE THE VEHICLE IS BEING OPERATED RESULTING IN REDUCED DRIVER VISIBILITY AND A POSSIBLE CRASH. CORRECTION: VEHICLES WITH 1992 MODEL HOODS WILL HAVE AN IMPROVED HOOD LATCH STRIKER INSTALLED AND REVISED STRIKER PLATE ATTACHING FASTENERS WILL BE INSTALLED ON VEHICLES WITH 1993-97 HOODS.
A failure of this component (structure) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.