Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Ford F-450 Super Duty model year.
Safety recall notices and repair campaigns registered for the 2017 Ford F-450 Super Duty in Canada.
On certain vehicles, there could be a problem with the connections inside the rearview camera. As a result, the rearview camera image may not display correctly or at all when the transmission is shifted into reverse. Note: For certain models, this recall also affects incomplete vehicles.
A rearview camera image that doesn't display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash.
Ford will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the rearview camera.
Over time, a damper inside the driveshaft may move and cause a vibration. If you continue driving with this vibration, the driveshaft could break and cause a loss of power to the wheels. Additionally, the truck could move when the transmission is in Park and the parking brake is not used. Note: This recall only affects certain 4x4 models with a 176" wheelbase, and a 4.1 or 4.3 rear axle ratio.
A loss of power to the wheels could increase the risk of a crash. A parked vehicle that rolls away could also create the risk of an injury or a crash.
Ford will notify owners by mail and instruct you to take your truck to a dealership to replace the driveshaft.
Over time, the coating on the lens for the rearview camera could degrade. If this happens, the rearview camera image may appear foggy or cloudy. Note: This recall only affected vehicles equipped with 360-degree camera systems.
A rearview camera image that does not display correctly could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash.
Ford will notify owners by mail and instruct you to take your vehicle to a dealership to replace the rearview camera.
On certain Super Duty models equipped with a SuperCrew cab, after a crash where a front seat belt pretensioner deploys, the carpet and/or carpet insulation could catch fire.
A fire that occurs after a crash could create an increased risk of injury.
Ford will notify owners by mail and instruct you to take your vehicle to a Ford or Lincoln dealer for repair. The dealer will apply foil tape to the carpet and carpet insulation, and modify the sound deadener on the back side of both driver and passenger side B-pillar trim panels as needed.
On certain Super Duty trucks, the electric tailgate latch could malfunction. This may cause the tailgate to unlatch on its own. If the tailgate opens while driving, cargo that is not secured could fall out of the truck bed and onto the road.
Cargo that falls from the truck bed could create a road hazard for others.
Ford will notify owners by mail and instruct you to take your vehicle to a Ford or Lincoln dealer to modify the tailgate/frame wiring harnesses and will install a new tailgate handle release switch.
The connectors on the engine block heater cable may have been damaged when your truck was serviced for recall campaign 2018-718 (Ford #18S45). This could cause a short-circuit, which may result in overheated or melted wiring.
Overheated or melted wiring could create the risk of a fire.
Stop use of your engine block heater immediately. Ford will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. Ford will send you another notice when replacement parts are available, and will ask you to take your vehicle to a dealer to install them. Do not use your engine block heater until the replacement parts are installed.
Water and contaminants may damage and corrode the block heater cable connectors. This could cause a short-circuit, which may result in overheated or melted wiring.
Overheated or melted wiring could create the risk of a fire.
Stop use of your engine block heater immediately. Ford will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. Ford will send you another notice when replacement parts are available, and will ask you to take your vehicle to a dealer to install them. Do not use your engine block heater until the replacement parts are installed.
On certain vehicles, door latch shielding may not be sufficient. As a result, water could enter into the side door latch and freeze, causing the latch mechanism to bind after opening. In addition, latch actuation cables may have been bent or kinked during installation, and could result in latch binding. A frozen door latch, or bent or kinked actuation cable may result in a door that will not open or will not close. If a latch does not fully engage the door striker, there is a potential for a door to open while the vehicle is in motion, which could increase the risk of injury. Correction: Dealers will install water shields over the door latches and the door latch actuation cables will be inspected and repaired if needed.
A failure of this component (structure) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain vehicles equipped with a front passenger side manual seat track may fail to conform to Canada Motor Vehicle Safety Standard (CMVSS) 207 - Anchorage of Seats and CMVSS 210 – Seat Belt Anchorages. If the front passenger seat track does not have sufficient weld penetration between the seat belt anchor and the seat cushion frame, the front seat passenger may not be properly restrained in the event of a crash, increasing the risk of injury. Correction: Dealers will replace the manual seat track.
A failure of this component (seats and restraints) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles equipped with a 6.7L diesel engine and a middle position fuel tank, there could be inadequate adhesion between the protective shield and the fuel conditioning module. This could allow for the the shield to be dislodged by road debris or water spray, which could force open the drain valve on the module. If the drain valve were to be forced open, this could result in substantial fuel leak. It could also allow for air ingress into the fuel system, which may cause the engine to stumble. A substantial fuel leak on a road surface could increase the risk of a crash, and a fuel leak in the presence of an ignition source could result in a fire causing injury and/or property damage. Correction: Dealers will replace the adhesive mounted protective shield on the fuel conditioning module with a bolt-on metallic protective shield.
A failure of this component (fuel system) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.