Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Freightliner 122sd model year.
Safety recall notices and repair campaigns registered for the 2021 Freightliner 122sd in Canada.
On certain trucks, the fasteners for the axle clamp(s) may not have been tightened properly. As a result, the clamps could loosen. If this happens, the axle could move and cause a loss of steering control. Note: This recall only affects certain trucks equipped with a TufTrac Gen 2 suspension.
A loss of steering control could create the risk of a crash.
Daimler Truck North America (DTNA) will notify the owners by mail and advise you to take your truck to a DTNA authorized service facility to inspect and tighten the axle clamp fasteners. The axle clamp castings will be replaced, as necessary.
On certain trucks, the joint connecting the steering arm to the drag link may not have been properly tightened. As a result, the joint could loosen and separate, causing a loss of steering control.
A loss of steering control could create the risk of a crash.
Daimler Truck North America (DTNA) will notify owners by mail and instruct you to take your truck to a DTNA authorized service facility to inspect the castle nut on the drag link taper joint. The nut will be checked for the correct torque, and tightened or repaired, as necessary.
On certain trucks, the tie rod arm and steering arm bolts may be defective and could break. If this happens, there could be a loss of steering control. Note: This recall only affects trucks built with a Detroit front axle.
A loss of steering control could create the risk of a crash.
Daimler Trucks North America (DTNA) will notify owners by mail and instruct you to take your truck to a DTNA authorized service facility to replace the tie rod arm bolts and the steering arm bolts.
On certain trucks equipped with "Fleet Engineer" mud flaps, the bracket for the mud flaps may partially cover the rear reflective tape. Canadian regulations require that reflective tape must be visible on the rear of the truck.
Reflective tape that is covered may make the truck less visible to others and could create an increased risk of a crash.
Daimler Trucks of North America (DTNA) will notify owners by mail and instruct you to take your truck to an authorized DTNA Service Facility to inspect the reflective tape. It will be moved as necessary to meet the regulations.
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.