Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Freightliner Conventional model year.
Safety recall notices and repair campaigns registered for the 1986 Freightliner Conventional in Canada.
THE STEERING ARM USED ON THE EATON EFA-12FA FRONT AXLE MAY FAIL WHEN USED IN CONJUNCTION WITH ROSS HFB-70 POWER STEERING GEARS IF TORQUE LIMITING FEATURES ARE NOT MAINTAINED. A FAILED STEERING ARM WOULD CAUSE LOSS OF VEHICLE CONTROL AND COULD RESULT IN A CRASH WITHOUT PRIOR WARNING. CORRECTION: INSTALL A NONADJUSTABLE 1500 PSI POWER STEERING PUMP PRESSURE RELIEF VALVE TO LIMIT STEERING ARM FORCES. REPLACE STEERING ARM WITH A DESIGN CAPABLE OF WITHSTANDING HIGHER FORCES. ADJUST MAXIMUM POPPET VALVE SETTINGS TO 500 PSI AND ADJUST AXLE STOPS.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: MODEL FLC-112 CONVENTIONAL TRUCKS. VEHICLES WERE BUILT WITH INCORRECT SIZE AIR BRAKE ACTUATOR CHAMBERS. THIS COULD RESULT IN INCREASED STOPPING DISTANCES AND A POSSIBLE VEHICLE CRASH. CORRECTION: AIR BRAKE CHAMBERS WILL BE REPLACED WITH CHAMBERS OF THE CORRECT SIZE.
A failure of this component (brakes) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
AN ELECTRICAL SHORT CIRCUIT CAN DEVELOP BETWEEN A POSITIVE BATTERY POST AND THE BATTERY RETAINER FRAME. THE POSITIVE BATTERY CABLE MAY ALSO CHAFE ON THE BATTERY RETAINER FRAME AND RESULT IN A SHORT CIRCUIT AND POSSIBLE FIRE. CORRECTION: "PICTURE FRAME" BATTERY RETAINER WILL BE REPLACED WITH "I-FRAME" TYPE BATTERY RETAINER AND CONVOLUTED TUBING WILL BE INSTALLED OVER POSITIVE BATTERY CABLE.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
THE HANDHOLD MOUNTING SYSTEM CONSISTS OF A TUBULAR HANDLE HELD IN THREE PLACES BY CAST ALUMINUM BRACKETS WHICH ARE, IN TURN, ATTACHED TO THE ENGINE EXHAUST MUFFLER HEAT SHIELD. VIBRATION FROM THE EXHAUST SYSTEM CAUSES THE HANDHOLD PARTS TO WEAR THIN AND COULD CAUSE THE HANDHOLD TO GIVE WAY UNDER THE WEIGHT OF A DRIVER. THIS COULD RESULT IN PERSONAL INJURY. CORRECTION: REPLACE THE HANDHOLD WITH A MODIFIED DESIGN WHICH UTILIZES A RUBBER ISOLATOR. ADD A PLASTIC SLEEVE TO THE CENTER BRACKET FOR ISOLATION.
A failure of this component (structure) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.