2016 GMC Yukon Recall

On certain vehicles, there may be an error in the electronic-brake control module software. This could cause the driveline-protection system to activate when a wheel-speed sensor fails. If this happens, the brakes could apply and cause the vehicle to pull to one side. Note: This recall only affects vehicles equipped with four-wheel drive, a 5.3-L engine, and a 3.08 ratio rear axle. The problem can only occur when the vehicle is in four-wheel drive or automatic mode, and travelling at a speed between 66 and 97 km/h (41 and 60 mph). A wheel-speed sensor failure will cause the electronic stability control (ESC) and anti-lock braking system (ABS) warning lights to turn on, and a "Service StabiliTrak" message to display.

A vehicle that suddenly pulls to one side could increase the risk of a crash.

General Motors will notify owners by mail and instruct you to take your vehicle to a dealer to update the electronic-brake control module software. General Motors advises that using two-wheel-drive mode can eliminate the risk until the recall repair is completed.

This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act.

Glass that breaks in to large pieces could create a risk of injury.

The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.

On certain vehicles, there could be a reduction in power brake assist due to a decrease in output from the vacuum pump. This could cause a hard brake pedal and an increase in brake pedal effort to stop the vehicle.

A sudden increase in brake pedal force could lead to an increase in stopping distance. This could increase the risk of a crash.

The company will notify owners by mail and instruct them to take their vehicle to a dealer to reprogram the electronic brake control module.

On certain vehicles equipped with Continental P275/55R20 CrossContact LX20 tires, a manufacturing defect could cause a lack of adhesion between belts in the tire. Affected tires may exhibit localized tread wear, excessive vibration, noise and bulging in the tread area. Continued use could cause the belts to separate, which could lead to full belt/tread loss. This could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect tire date code markings to determine whether they are from the affected date code. Affected tires will be replaced.

A failure of this component (tires) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, the sensing and diagnostic module (SDM), which controls airbag and pretensioner deployment, contains a software defect which may prevent the deployment of frontal airbags and pretensioners in certain circumstances. Failure of frontal airbags and seatbelt pretensioners to deploy in a crash (when warranted) could increase the risk of injury. Correction: Dealers will reflash the SDM with new software. In vehicles with any previous deployment events recorded in the SDM, the dealers will replace the existing SDM with a new SDM containing the latest software. Note: This recall affects 2014-2017 model year Sierra LD/Silverado LD models and 2015-2016 model year Sierra HD/Silverado HD model vehicles.

A failure of this component (airbag) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

Certain vehicles may have been built with front upper control arms with a poor quality weld near the control arm’s bushing. If these welds were to fail, it could cause the upper control arm to deform or separate from the bushing, which could affect steering and directional control of the vehicle, increasing the risk of a crash causing injury and/or property damage. Correction: Dealers will replace the left and right front upper control arms, and perform a realignment.

A failure of this component (suspension) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).