Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Nissan Pathfinder model year.
Safety recall notices and repair campaigns registered for the 2005 Nissan Pathfinder in Canada.
On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash. Note: This recall is for certain vehicles that had the steering wheel airbag replaced.
Projectiles in the occupant compartment could increase the risk of an injury.
Nissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the steering wheel airbag cover.
This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act.
Glass that breaks in to large pieces could create a risk of injury.
The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.
On certain vehicles the Intelligent Power Distribution Module (IPDM) assembly contains an Engine Control Module (ECM) relay that has a diode for electrical current noise reduction. The ECM relay may allow silicon vapor to form and over time the silicon evaporates from the diode molding which causes silicon oxide to develop on the ECM relay contact due to arcing. In certain instances, this oxidation could cause engine performance issues (hesitation, rough engine idle, slow start/no-start condition), and engine stalling at low engine speeds which may result in a crash. Correction: Dealers will replace the Engine Control Module (ECM) relay.
A failure of this component (engine) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles operated in areas of heavy road salt usage, the front Crash Zone Sensor (CZS) may rust internally. This could result in the non-deployment of the driver and passenger front airbags during a vehicle crash, increasing the risk of personal injuries or death in certain crash conditions. Correction: Dealers will replace the Crash Zone Sensor.
A failure of this component (airbag) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.