2018 Ford F-150 Recall

On certain trucks, the recall repairs completed by a Ford dealer during recall 20C03 (Transport Canada recall no. 2020-071) may not have been done correctly. As a result, a second repair is required. On certain trucks, a software problem could cause the daytime running lamps (DRLs) to remain on when switching the master lighting switch from the ''Autolamp'' position to the ''headlamp on'' position. Canadian regulations require the DRLs to turn off when the headlamps are switched on.

Daytime running lamps that stay on could cause glare for oncoming drivers and increase the risk of a crash.

Ford will notify owners by mail and advise you to take your truck to a dealership to update the body control module software.

On certain trucks, the recall repairs completed by a Ford dealer during recall 17S35 (Transport Canada recall no. 2017-517) may not have been done correctly. As a result, a second repair is required. Under certain conditions, the transmission gear selection indicator (PRNDL) may not work. Additionally, the transmission could shift into the reverse or neutral gear. This could cause sudden and unexpected vehicle movements. Note: This recall only affects certain trucks equipped with a 3.3 L engine and a 6-speed transmission.

A transmission gear selection indicator that doesn't work could create confusion. A vehicle that moves unexpectedly could increase the risk of a crash.

Ford will notify owners by mail and advise you to take your truck to a dealership to update the powertrain control module software.

On certain trucks, the windshield wiper linkage could corrode and seize. If this happens, the windshield wipers may not work.

Windshield wipers that don't work could reduce visibility and increase the risk of a crash.

Ford will notify owners by mail and advise you to take your truck to a dealership to replace the windshield wiper linkage.

On certain trucks, the tailgate could unlatch and open while driving. If this happens, cargo that is not secured could fall out of the truck bed and onto the road.

Cargo that falls from the truck bed could create a road hazard for others.

Ford will notify owners by mail and instruct you to take your truck to dealer to replace both left and right-hand tailgate latches.

Certain vehicles were built with tires that may have been cured too long. As a result, the sidewall could crack or the tread and belts could separate. This could lead to a sudden loss of air pressure and could cause a tire failure. Note: This recall only affects certain Continental tires, with specific date codes and mold numbers.

A tire failure could cause a loss of control and increase the risk of a crash.

Ford will notify the owners by mail and instruct them to take the vehicle to a dealer to inspect and replace the tires, if necessary.

On certain trucks, there may be a problem with the software that controls the daytime running lights (DRLs). When the DRLs are on and the master lighting switch is rotated from the “Autolamp” position to the “headlamp on” position, the DRLs do not lower to parking light brightness. Canadian regulations require that the DRLs turn off when the headlights are turned on. Note: This only affects trucks equipped with LED headlights and the Autolamp feature (automatic headlights).

Lights that are too bright could cause glare for oncoming drivers.

Ford will notify owners by mail and instruct you to take your truck to a Ford or Lincoln dealer to update the body control module (BCM) software.

On certain trucks, the electric tailgate latch could malfunction. This may cause the tailgate to unlatch on its own. If the tailgate opens while driving, cargo that is not secured could fall out of the truck bed and onto the road.

Cargo that falls from the truck bed could create a road hazard for others.

Ford will notify owners by mail and instruct you to take your vehicle to a Ford or Lincoln dealer to modify the tailgate/frame wiring harnesses and will install a new tailgate handle release switch.

On certain vehicles, seats with a manual recliner may not meet the strength requirements of Canadian regulations. A seatback with reduced strength may not properly restrain an occupant in a crash.

A seatback that moves in a crash could increase the risk of injury.

Ford will notify owners by mail and instruct them to take their vehicle to a Ford or Lincoln dealer for an inspection of the driver and front passenger seat recliners. For 2020 model year Explorer and Aviator, dealers will inspect the rear outboard seats. The seat structures will be replaced as required.

This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act.

Glass that breaks in to large pieces could create a risk of injury.

The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.

The connectors on the engine block heater cable may have been damaged when your truck was serviced for recall campaign 2018-718 (Ford #18S45). This could cause a short-circuit, which may result in overheated or melted wiring.

Overheated or melted wiring could create the risk of a fire.

Stop use of your engine block heater immediately. Ford will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. Ford will send you another notice when replacement parts are available, and will ask you to take your vehicle to a dealer to install them. Do not use your engine block heater until the replacement parts are installed.

Water and contaminants may damage and corrode the block heater cable connectors. This could cause a short-circuit, which may result in overheated or melted wiring.

Overheated or melted wiring could create the risk of a fire.

Stop use of your engine block heater immediately. Ford will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. Ford will send you another notice when replacement parts are available, and will ask you to take your vehicle to a dealer to install them. Do not use your engine block heater until the replacement parts are installed.

On certain vehicles, the activation of the front seat belt pretensioners in a crash may result in momentary ignition of pretensioner exhaust gases. This could ignite materials in the B-pillar area, leading to a fire causing injury and/or damage to property. Correction: Dealers will inspect the B-pillar area, modify the floor covering and sound insulation, and apply heat-resistant tape.

A failure of this component (seats and restraints) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, the high-pressure fuel pump may have been improperly manufactured and could fracture at its mounting flange. This could cause an oil or fuel leak which, in the presence of an ignition source, could increase the risk of fire, causing injury and/or damage to property. Correction: Dealers will replace the high-pressure fuel pump, high-pressure discharge tube and mounting bolts.

A failure of this component (fuel system) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, a roll pin attaching the park pawl rod guide cup to the transmission case may not have been installed. Over time, this could cause the transmission to lose the Park function even when the shifter and instrument panel display PARK. If the parking brake is not applied, this could result in unintended vehicle movement, which would increase the risk of crash causing injury and/or damage to property. Correction: Dealers will inspect and install the missing roll pin as necessary.

A failure of this component (powertrain) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles, a clip that locks the gear shift cable to the transmission may not be fully seated. Over time, this could allow the transmission to be in a gear state different than the gear shift position selected by the driver. This condition could allow the driver to move the shifter to Park and remove the ignition key while the transmission gear may not be in Park. If the parking brake is not applied, this could result in unintended vehicle movement, which would increase the risk of crash causing injury and/or damage to property. Correction: Dealers will inspect the shift cable locking clip and reseat it as necessary.

A failure of this component (powertrain) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles equipped with 3.5L V6 engines, certain cylinder heads are missing machined holes intended to supply lubrication to the camshaft bearing journals. Lack of proper camshaft lubrication will result in premature engine failure and loss of motive power while the vehicle is in motion, which could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will replace the engine.

A failure of this component (engine) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

On certain vehicles equipped with a 3.3L V6 engine, 6-speed transmission and a column mounted gear shift lever, rapid movement of the transmission shifter from Park to Drive may cause loss of PRNDL gear indication in the instrument cluster, and momentary engagement of Reverse operation before the vehicle achieves forward Drive function. This could result in unintended vehicle movement, or alternatively, an operator may experience momentary Neutral operation rather than Reverse. Unintended vehicle movement may increase the risk of injury and/or damage to property. Correction: Dealers will reprogram the Powertrain Control Module with new software.

A failure of this component (powertrain) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).