Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Ford F Series model year.
Safety recall notices and repair campaigns registered for the 1995 Ford F Series in Canada.
On certain B600, F600 and P800 vehicles, engine resonance can cause elevated stress conditions and a fatigue failure of the accelerator return springs. A failed return spring could result in the engine not fully returning to idle when the accelerator pedal is released. Correction: Accelerator return springs will be replaced with a torsion spring design.
A failure of this component (engine) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
NOTE: SUPER CAB PICKUPS WITH OPTIONAL 40/20/40 POWER FRONT DRIVER SEAT. THE FRONT SEAT CUSHION SUPPORT WIRES COULD CONTACT AND DAMAGE THE INSULATION ON THE WIRE HARNESS FOR THE POWER LUMBAR FEATURE. THIS COULD RESULT IN A HIGH RESISTANCE ELECTRICAL SHORT CIRCUIT THROUGH THE SUPPORT WIRES. OVERHEATING OF THE SUPPORT WIRES MAY RESULT, CAUSING MELTING, SMOKE OR POTENTIALLY, IGNITION OF SURROUNDING MATERIALS. CORRECTION: VEHICLES WILL BE INSPECTED AND IF NO DAMAGE IS FOUND, THE DRIVER SEAT WIRE HARNESS WILL BE COVERED WITH A CONVOLUTE TUBING, WRAPPED WITH ELECTRICAL TAPE AND REROUTED. IF DAMAGED, THE HARNESS WILL BE REPLACED
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain B600, B700, F600, F700, F800, FT900, LA9000, LL9000, LTA9000 and LTL9000 vehicles, a connector where the wiring for lamps mounted on the tilt hood attaches to the vehicle wire harness was built without sealing plugs in the unused cavities of the connector. Road salt, moisture or other contaminants may enter the connector, which could result in crossed circuits, shorts or corrosion of the wiring in the connector and a malfunction of the headlamps or other front-end lighting systems. Correction: Sealing plugs will be installed in the unused connector cavities. If corroded, a new connector will be installed.
A failure of this component (electrical) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
THESE VEHICLES MAY HAVE BEEN BUILT WITH IGNITION CONTROL (IC) MODULES WHICH MAY FAIL AND CAUSE A NO START CONDITION. A FAULTY IC MODULE WOULD NOT BE IN COMPLIANCE WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. CORRECTION: VEHICLES WILL BE INSPECTED AND IC MODULE WILL BE REPLACED IF NECESSARY.
A failure of this component (emissions) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.