2018 Peterbilt 365 Recall

On certain trucks, the fasteners that attach the steer arm to the steering knuckle may fail. If this happens, the steer arm could separate from the steering knuckle and cause a loss of steering control. Note: This recall only affects trucks equipped with a Dana D-series steer axle.

A loss of steering control could increase the risk of a crash.

PACCAR will notify owners by mail. The corrective actions for this recall are under development.

On certain trucks, the fuel rail assembly could develop a leak. Note: This recall only affects trucks equipped with a Cummins L9 or ISX12 diesel engine.

A fuel leak can create the risk of a fire.

Cummins will notify owners by mail and instruct you to take your truck to a Cummins authorized service center to inspect the fuel rail. If damage is found, the fuel rail and fuel lines will be replaced. If no damage is found, the fuel rail will be reassembled with new crush washers using a special tool.

On certain trucks, the warning light for the tractor anti-lock brake system (ABS) may not turn on if the system loses power. If this happens, the driver will not get warning that the ABS is not working properly. Note: This problem would also cause the traction control (TC) and electronic stability control (ESC) lights not to turn on.

If a driver is not warned that the ABS is not working properly, there could be an increased risk of a crash.

PACCAR will notify owners by mail and instruct you to take your truck to a dealer to update the software for the cab control module (CECU).

On certain trucks, the battery cables to the jump-start terminal may be too long. As a result, the cables could contact and chafe against the left-front suspension leaf spring. If this happens, a short circuit could occur and cause the positive cable to overheat or melt. Note: This recall only affects trucks with a left-hand under-hood battery jumper terminal.

An overheated or melted battery cable could create the risk of a fire.

The company will notify owners by mail and instruct you to take your truck to a dealer for an inspection of the jump-start terminal cables. If the cables are too long, they will be replaced.

On certain vehicles equipped with an Eaton automated manual transmission and electronic clutch actuator (ECA), the clutch may have been manufactured improperly and could fail. If this occurs, the broken clutch components could prevent the transmission from disengaging or shifting to neutral. This could result in unintended vehicle movement, even if the parking brake is applied, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will recalibrate the Transmission Control Module (TCM).

A failure of this component (powertrain) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).

Certain vehicles may fail to conform to the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 121 - Air Brake Systems and CMVSS 136 - Electronic Stability Control Systems for Heavy Vehicles. In the event that the anti-lock brake system (ABS) loses battery and/or ignition power to the controller, the ABS indicator lamp may not illuminate to warn the driver of the loss of ABS, which is contrary to the requirements of the standards. This could result in the loss of ABS function with no warning to the driver, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will reprogram the cab control module.

A failure of this component (brakes) may increase the risk of a crash or injury.

Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).