Safety defect investigations, technical specifications, and manufacturer repair notices for Canadian owners.
Enter a VIN to identify your vehicle and find Canadian recall notices that may apply to its make, model and year. Confirm VIN-specific eligibility and repair status with the manufacturer.
Switch to another Thomas Built Saf-T-Liner C2 Non-School Bus model year.
Safety recall notices and repair campaigns registered for the 2009 Thomas Built Saf-T-Liner C2 Non-School Bus in Canada.
On certain vehicles equipped with Kidde fire extinguishers with black plastic handles and valves, the fire extinguishers may become clogged or require excessive force to activate. Also, the nozzle may detach from the valve assembly with enough force that it could cause injury, and fail to discharge. In case of fire, failure of the extinguisher to function could result in injury and/or property damage. Correction: Owners will be provided with instructions on how to inspect the fire extinguisher to see if it is recalled. Replacement fire extinguishers will be supplied by Kidde directly. Note: For more information about recalled fire extinguishers, please visit www.kidde.com.
A failure of this component (accessories) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain buses, the stem which joins the outside emergency door handle to the emergency door opening mechanism may potentially corrode. Excessive material loss of the stem due to corrosion could result in the outside handle separating from the door mechanism while trying to open the door from the exterior of the bus. In the event of an emergency, this could delay evacuation of the vehicle and increase the risk of injury to occupants. Correction: Dealers will inspect the stems and either replace or protect them agianst further corrosion.
A failure of this component (structure) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Certain buses may not comply with Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. The Daytime Running Lights (DRL) may not illuminate when the master lighting switch is set to the parking lamps position. No DRL illumination could render the vehicle less visible to other motorists and pedestrians during daylight hours, which could result in a crash causing property damage and/or personal injury. Correction: Dealers will update the DRL configuration on affected vehicles.
A failure of this component (lights and instruments) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles equipped with a Carrier GenV EM-1 evaporator unit, the blower motor fuse assembly may allow the fuse to loosen over time, which could result in high resistance and arcing. If sufficient arcing occurs the fuse holder may melt, which could cause smoke and/or fire. A vehicle fire could result in property damage and/or personal injury. Correction: Carrier will provide a retrofit kit along with installation instructions.
A failure of this component (accessories) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles equipped with an MBE900 (EPA04 and EPA07) engine, the intake air grid heater may short circuit and fail. This could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will install an additional external relay to prevent battery connection to the grid heater when the vehicle is not running and when grid heater control signal is absent.
A failure of this component (other) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the weld around the steering shaft tube, which joins the splined tube to the non-splined intermediate tube, may be mislocated. An improperly located weld bead may allow the splined tube and non-splined tube to rotate relative one another during a low speed, high torque turn, resulting in a possible separation of the tubes. This could cause a loss of steering control which could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the steering shaft.
A failure of this component (steering) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain vehicles, the stop lamps may operate intermittently during light braking applications. Failure of the brake lamps to illuminate when the brakes are applied may result in the following road users being unaware of the driver's intentions, increasing the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the hydraulic brake light switch assembly.
A failure of this component (lights and instruments) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain buses, the entrance door glass may be inadequately bonded to the door frame. As such, the glass may separate from the door assembly and strike a vehicle, property, or a bystander, which could result in property damage, personal injury or death. Correction: Dealers will affect repairs.
A failure of this component (other) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
On certain buses, contacts in the pressure switch for the low current brake lamp signal to the chassis Electronic Control Unit (ECU) may become contaminated by the presence of silicone used during assembly. Over time insulating deposits may build up on the contacts and affect the operation of the brake lamp signal to the chassis ECU, thereby preventing brake lamp illumination. Failure to clearly indicate intentions to following motorists could result in a vehicle crash causing injuries or death. Correction: Dealers will replace the pressure switch "A" module in the Air Management Unit (AMU).
A failure of this component (other) may increase the risk of a crash or injury.
Authorized dealerships will inspect the vehicle and complete all necessary repairs free of charge (parts and labor).
Official Transport Canada safety campaigns, Canadian motor vehicle safety compliance standards and live VIN specifications.
Explore safety recall records by model year.